User's Manual

Table Of Contents
Page 12
Chapter 4. Connecting the Power System
The RadioRouter BaseStation Outdoor Cabinet requires a connection to AC power. This chapter
contains procedures for routing the power c able and connecting to power and ground.
WARNING:
WHEN P ERF ORMING ANY TASKS INVOLVING THE POWER SYSTEMS,
MAKE SURE THAT THE P OWER IS NOT LIVE. ALL POWER OPERATIONS
SHOULD BE PER FORMED BY QUALIFIED PERSONNEL ONLY.
Procedure 4-1 Routing the Power Cable
The main power cable is routed into the cabinet from the left rear of the cabinet up to the AC
Load Center. See Figure 4.1 Power Cable Entry Rear View and Figure 4.2 Path of Power
Cable to AC Load Center Rear View. Internal cabinet wiring routes the power from the load
center to the equipment in the base station.
For this procedure you will need:
Handle hex tool key Sierra Pacific part number 392–K or equivalent
Conduit pull box with hole diameter 1.375” to 1.50”
Figure 4.1 Power Cable Entry Rear View
RadioRouter
®
BaseStation Installatio n Gu ide Draft
Version 0.2 - © 2003 Flarion
Flarion Confidential
Page 12