User's Manual

Page 6
Chapter 3. Installing the Cabinet
The RadioRouter BaseStation cabinet is shipped assembled, shrouded in cardboard, and
mounted on a shipping pallet.
WARNING:
THE RADIOROUTER BASESTATION OUTDOOR CABINET WEIGHS
APPROXIMATELY 1150 LB AND IS TOP HEAVY. CARE MUST BE TAKEN
TO HANDLE TH E CABINET PROPERLY WITHOUT DANGER TO THE
INSTALLATION PERSONNEL OR OTHER NEARBY EQUIPMENT.
Equipment that can be used to move the base station is described in Section 1.1. Installation
Equipment.
Procedure 3-1 Removing the Cabinet from the Pallet
When this procedure is completed, the cabinet will be free to move directly into place.
1.
Remove the cardboard shroud and discard.
2.
Inspect the cabinet for damage. If there is any damage, fill out the Punchlist in Appendix B -
Outdoor BaseStation Installation Punchlist. If the damage is minor and does not prevent
continuation of the installation procedures, continue with the installation. If the damage
prevents continuation of the installation, contact the Project Manager for instructions.
3.
Remove the rear access screw panels. Figure 3.1 Outdoor Cabinet Rear Screw Panels
shows the location of the panels. A tamper resistant insert hex bit, Wiha part number
71940, is required to remove the tamper resistant screws.
Note:
Save all removed screws. Reinstallation of the rear panel and side panels is required, and you
must use the same tamper resistant screws that were removed.
RadioRouter
®
BaseStation Installatio n Gu ide — Draft
Version 0.2 - © 2003 Flarion
Flarion Confidential
Page 6