User's Manual
Table Of Contents
- toc
- Issue Date: 08- 04- 2003
- Overview
- Verifying the Site Preparation
- 2.1. Site Preparation Checklist •24 Indoor BaseStation
- 2.2. Preparing the Floor
- Installing the Cabinet
- Connecting the Power System
- 4.1. Routing the Cables
- 4.2. Connecting to Power and Ground
- Connecting the Core Network Cables
- Connecting the Antennas Cables
- Installing the Alarm Connections
- Powering Up the Cabinet
- Powering Down the Cabinet
- Verifying the Installation
- 10.1. Verifying the Physical Installation
- 10.2. Verifying the Base Station Operation
- RadioRouter BaseStation Site Preparation Punchlist
- RadioRouter BaseStation Installation Punchlist
- tables
Page 35
4.
Verify that the LEDs on the front of the cabinet match Table 8.1 Power On Expected LEDs.
If the LEDs do not match the table, power the system down and check the wiring.
WARNING:
AFTER THE RADIOROUTER BASESTATION IS POWERED UP, IT CAN NOT
BE POWERED DOWN WITHOUT THE USE OF A CRAFT ACCESS
TERMINAL. POWERING THE BASESTATION DOWN WITHOUT TH E USE
OF A CRAFT AC CESS TERMINAL COULD PERMANENTLY DAMAGE
THE EQUIPMENT.
Table 8 .1 Power On E xpected LEDs
Unit LED Name
Condition
PDU Fan Tray FAN Green
RRC FAN STA TUS Green
RRC FAN STA TUS Green
PCU1 ON (GREEN) FAIL (RED) Green
PCU2 ON (GREEN) FAIL (RED) Green
RadioRouter
®
BaseStation Installation Guide — Draft
Version 0.5 - © 2003
Page 35