User's Manual
Table Of Contents
- toc
- Issue Date: 08- 04- 2003
- Overview
- Verifying the Site Preparation
- 2.1. Site Preparation Checklist •24 Indoor BaseStation
- 2.2. Preparing the Floor
- Installing the Cabinet
- Connecting the Power System
- 4.1. Routing the Cables
- 4.2. Connecting to Power and Ground
- Connecting the Core Network Cables
- Connecting the Antennas Cables
- Installing the Alarm Connections
- Powering Up the Cabinet
- Powering Down the Cabinet
- Verifying the Installation
- 10.1. Verifying the Physical Installation
- 10.2. Verifying the Base Station Operation
- RadioRouter BaseStation Site Preparation Punchlist
- RadioRouter BaseStation Installation Punchlist
- tables
Page 21
Chapter 5. Connecting the Core Network C ables
The RadioRouter BaseStation can access the core network through either T1 or Ethernet
connections. This section descr ibes both methods.
Procedure 5-1 Connecting to the Network via T1
T1 connections are made using cables terminated in RJ-48 c onnectors.
1.
Locate the T1 connectors on the rear of the cabinet.
Figure 5.1 Cabinet with T1 Connectors — Rear View
RadioRouter
®
BaseStation Installation Guide — Draft
Version 0.5 - © 2003
Page 21