User manual

11
GBFRIT DE
Note: Maintain a minimum distance of one metre between the
radio modules, even during installation.
Creating a radio group
At any one time, activate only the two radio modules that are to be
programmed and not every module simultaneously. Hold down the
button (Fig. 1.2) on a radio module for approximately 2–3 seconds. The
red LED (Fig. 1.1) then begins to flash approximately once every second.
Release the button again. The radio module enters programming mode for
approximately 60 seconds. After this period, immediately press the button
(Fig. 1.2) on another radio module for approximately 2–3 seconds. The
red LED (Fig. 1.1) then begins to flash approximately once every second.
Release the button again. The radio module enters programming mode
for approximately 60 seconds. During this time, both radio modules
reciprocally program themselves into a radio group automatically. The
programming process can take up to approximately 60 seconds in total.
If programming was successful, the red LEDs (Fig. 1.1) on both radio
modules light up permanently for 2–3 seconds. If after approximately 60
seconds the red LEDs do not light up permanently for 2–3 seconds, the
programming process was not successful and the radios modules return
to normal mode. In this event, the programming process must be repeated.
Up to 30 radio modules can be assigned to a radio group.
Expanding an existing radio group
At any one time, activate only the two radio modules that are to be
programmed and not every module simultaneously. To expand an
existing radio group, switch any radio module from the radio group to be
expanded to the programming mode by holding down the button (Fig 1.2)
for approximately 2–3 seconds. For the other radio modules, do not plug
the three-pin terminals of the radio modules (Fig. 1.3) onto the detector.
The red LED (Fig. 1.1) then begins to flash approximately once every
second. Release the button again. The radio module enters programming
mode for approximately 60 seconds. After this period, immediately
press the button of the radio module to be added for approximately 2–3
seconds. The red LED then begins to flash approximately once every
second. Release the button again. The radio module enters programming
mode for approximately 60 seconds. During this time, the radio module
to be added will be automatically incorporated into the existing radio
group. The programming process can take up to approximately 60
seconds in total.
Creating an additional radio group
At any one time, activate only the two radio modules that are to be
programmed and not every module simultaneously. Proceed in the same
manner as described in the section entitled „Creating a radio group“.
Program only the radio modules to be incorporated into the additional
radio group. During this process, do not integrate a radio module that is
already assigned to another radio group. It is possible to create up to eight
independent radio groups.
Note: The button (Fig. 1.2) is locked for five minutes after being
activating. This also applies for the radio modules that have received
the test radio message.
Deleting programmed settings/factory setting
Press and hold down the button (Fig. 1.2) on the radio module that you want
to delete for approx. 5 seconds until the red LED (Fig. 1.1) starts flashing
approx. twice per second. When you have held the button down for approx.
2-3 seconds, it will initially start flashing approx. once per second. Continue
to hold down the button until the LED starts flashing twice as fast. Release
the button. The radio module confirms deletion by emitting a short beep
and then returns to standard mode. However, the device does not belong
to a radio group.