User Manual
Power Steering Pump Bracket
Included in the FR1610 kit is a ½” feed line that connects from the remote reservoir to the power steering pump. is is
attached using the 2 stainless steel hose clamps. e 3/8” Double Crimped Pressure Line will attach the pressure port of
the powersteering pump and to the pressure side of your steering gear. AN ttings with o-rings are included to complete
the installation. e single crimped 3/8” line is used for the return line from the steering gear to the reservoir. is will
attach to the steering gear to the reservoir using a AN Fitting and the ¼”NPT barbed tting with a stainless steel hose
clamp. Custom length hose kits can be ordered from Flaming River by providing a drawing with dimensions.
When cutting the stainless steel hose it is easier to use a chop saw or cut o wheel. Wrap the hose in black electrical tape
and cutting through the tape to help avoid fraying. You may need to use a side cutter to trim any frayed stainless steel
line. e lines can be installed to the 90 degree ttings loose until to ensure proper line routing. To tighten, hold the line
itself and tighten the ttings to 10-12 lbs.
Note: Over crimping or kinking the line my cause damage
to the Teon liner and voids warranty.
12
Flaming River Industries
1-800-648-8022
FRxxxx Rev.A
12/15/10
Power Steering Lines (FR1610 Not included in Kit)
Note: If you are not using
FR1610 P/S Line Kit you must
order FRM14x6AN & FRM16x6AN
AN Fittings for the rack.