Owner's manual

Power Steering Bleeding Procedure
1) Raise the front wheels off the ground and
support the vehicle on jack stands.
2) Turn the steering wheel to the left lock
 andllthereservoirandletthevehiclesit
for 2 minutes.
3) WITH THE ENGINE OFF - Rotate the
steering wheel lock to lock 20-25 times,
while rotating the wheel have someone
 monitortheuidlevelandllas  
necessary.
4) Topoffuid
5) WITH THE ENGINE RUNNING - Rotate
the steering wheel lock to lock 20-25
times, while rotating the wheel
 havesomeonemonitortheuidleveland
 llasnecessary.
6) Lower the vehicle
7) Topoffuid
8) WITH THE ENGINE RUNNING - Rotate
the steering wheel lock to lock 20-25
times, while rotating the wheel
 havesomeonemonitortheuidleveland
 llasnecessary.
Install your power steering lines to the correct
pressure or return ports.
9
Flaming River Industries
1-800-648-8022
FRxxxx Rev.A
01/05/11
If using a stainless steel line kit, follow the instructions provided with your kit.
Note: If using the original power steering pump, you must rst ush the pump of any power steering uid.
Contaminated power steering uid may cause damage to the new rack and pinion.
Note: If the power steering uid is foamy, let the vehicle sit for 10 minutes and then repeat the bleeding procedure.
Note: Trapped air in the system will cause a milky appearance in the uid. Trapped air will also cause the uid level
to rise in the reservoir when the engine is not running.