Installation Guide

5
STANDARD INSTALLATION
• The cross base supplied with this offset umbrella
requires 4 individual base weights at least 48lb
(22kg) each for a minimum combined weight of
192lb (88kg) to provide the necessary support and
stability. As a general rule the more weight the better
the umbrella will be supported.
• Failing to use the minimum base weight will damage
the umbrella and may also cause personal injury.
SPECIAL INSTALLATION
• If you have a suitable timber deck, the cross base
can be secured to it using 2” (5cm) M8 coach
bolts or deck screws (not supplied). Ensure the
fixing points are made into joists or bearers not just
the decking boards. If using this option, extreme
care must be taken to ensure the umbrella is never
opened or used in wind greater than 5mph (8kph).
OFFSET UMBRELLA BASE TIPS
REPLACING THE BATTERIES
The batteries in your LED umbrella must be replaced at least once every year (or when you feel that the light
is fading more quickly). You can purchase replacement batteries at specialty retailers.
You will need 3 pieces AA size 1.2v 800mAh NIMH rechargeable batteries which are the same as have been
supplied from new.
Failure to insert batteries in the correct polarity, as indicated in the battery compartment, may shorten
the life of the batteries or cause them to leak. NEVER dispose of batteries in fire. Batteries must be
recycled or disposed of as per state and local guidelines. NEVER mix old and new batteries. NEVER
mix Alkaline, Standard (Carbon-Zinc) or rechargeable (Nickel Cadmium) or (Lithium) batteries together
in the solar panel.
Step 1
Twist the solar panel counter
clockwise and remove it from
the top of the umbrella.
Step 2
Carefully pull the plug out of the
socket under the solar panel.
IMPORTANT: Do not pull the
wire to remove the plug.
Step 3
Set the solar panel upside
down on a soft, clean surface
to avoid scratching. Loosen all
three screws on the bottom of
the solar panel.
Step 4
Carefully open the solar
panel. Replace the batteries,
matching the +/- on the battery
with the +/- on the battery case.
Step 5
Make sure the O ring is correctly
located before replacing the
cover.
Step 6
Re-assemble the solar panel. Do
not over tighten the screws.
CPULED06/CFSLED10Bv2022