Installation Guide

4
Step 6
Locate the umbrella in direct sunlight to charge the batteries before first use.
IMPORTANT NOTE: Charge the batteries for at least 8 hours in direct sunlight before first use, failing
to follow this step will shorten the lifespan of the re-chargeable batteries and decrease the
performance of the lights. Make sure both the switches on the rib are set to the “OFF” ‘O’ position
during charging.
To operate the lights, turn the switches (located on the end of one rib) to the ON (‘I’) position. Ensure
both switches are set to the OFF (‘O’) position when the lights are not being used.
IMPORTANT: If the lights are accidentally left on during the day the batteries will NOT charge and the
lights will not operate at night.
Step 3
When the umbrella arm is fully extended, lock the lift
clamp and slide the lock cover into place as shown.
Step 4
Turn the crank handle in a clockwise direction to
open the canopy (take care not to keep winding the
crank handle once the canopy is fully opened). Use
the tie strings provided at the back of the canopy to
secure it to the main umbrella pole.
Step 5
To close the umbrella, first undo the tie strings and then wind the crank handle gently in a counter clockwise
direction until the canopy is fully closed. CRITICAL STEP: Always remember to slide the lock cover
away from the vertical lift mechanism BEFORE lowering the umbrella arm. Unlock the lift clamp and
gently slide the arm downwards to fully lower the umbrella. Fasten the Velcro storage straps around the
canopy and main frame.
NOTE: A regular application of silicon spray to the sliding mechanisms will assist with smooth
operation.
O=OFF
I=ON
CPULED06/CFSLED10Bv2022