Installation Guide

3
OPERATING INSTRUCTIONS
Step 5
Place the assembled cross base in your preferred
location then follow the 'Cross Base Installation
Tips' on page 5.
Step 3
Locate the plug at the top of the umbrella. Carefully
insert the plug into the socket located on the
underside of the solar panel.
Step 6
Attach the main frame and canopy to the central
spigot. Ensure that the locating pin is positioned into
the cutout in the top of the central spigot. Tighten
the two tension screws firmly.
Step 4
Place the solar panel on the top of the umbrella
taking care to conceal the wires inside the gap
at the top of the umbrella, then gently turn the solar
panel in a clockwise direction to attach it to the
umbrella. Take care not to over tighten as this may
damage the umbrella and/or the solar panel.
F
Step 1
Unfasten the Velcro storage straps from the canopy
and main frame.
Step 2
Unlock the lift clamp. Gently slide the arm upwards
to fully extend the umbrella.
Storage
Straps
NOTE: The central spigot is designed with
a reverse angle to ensure the canopy sits
level once assembled. It is very important
to correctly locate the crank winder directly
above the tension screws as shown.
CPULED06/CFSLED10Bv2022