Installation Guide

ManualsBrandsFLAME&SHADE ManualsCantilever Umbrellas10 ft. Steel Cantilever Solar Lighted Patio Umbrella with Cross Base Stand in Ivory Solution Dyed Polyester

Table Of Contents

CPULED06/CFSLED10Bv2022

PLEASE READ CAREFULLY AND RETAIN FOR FUTURE REFERENCE

10' (3.0m) OFFSET LED PATIO UMBRELLA

SAFETY WARNING

Offset patio umbrellas are designed to provide protection from the sun NOT the wind.

• NEVER open or operate this umbrella in wind conditions greater than 5mph (8kph).

• NEVER use the tilt function in any wind (even a light breeze).

• NEVER use excessive force on the crank handle to open or close the umbrella.

• ALWAYS close and secure the umbrella when not in use or during any strong wind event, especially gusting

wind and rain.

• ALWAYS close the umbrella when unattended or not in use. If you are not sitting under it, the umbrella

should be closed.

• ALWAYS use the Velcro straps to properly secure the canopy to the frame when the umbrella is closed.

• Base weights are required (additional purchase) to secure this umbrella. NEVER open or operate the

umbrella without first placing base weights in each open section of the cross base. It is important to use a

correctly weighted base; more weight is always better than less weight. This model requires a MINIMUM

base weight of 192lb (88kg).

FAILURE TO CAREFULLY OBSERVE THESE SAFETY WARNINGS CAN RESULT IN CATASTROPHIC

DAMAGE TO YOUR UMBRELLA, POTENTIAL PERSONAL INJURY AND OR PROPERTY DAMAGE.

IMPORTANT INFORMATION

If the umbrella is showing ANY signs of stress, or IF the umbrella begins to move around excessively even

when properly weighted it indicates the wind is too strong and the umbrella must be closed and secured

immediately.

CARE AND MAINTENANCE

•

To help extend the life of the polyester fabric and reduce the effects of fading we strongly advise using a

protective storage cover whenever the umbrella is not being used.

•

During extended periods of bad weather (especially through winter months) your umbrella should be stored

inside in a dry place.

•

The polyester fabric has been treated to make it dirt and shower resistant (not waterproof), if your umbrella

gets wet please allow it to fully dry before storing it away. The fabric can be cleaned with a soft brush then

use a damp cloth and mild detergent to remove any stubborn stains.

BEFORE YOU START

•

Check you have all the listed parts before you start assembling.

•

Assemble on a soft surface such as a drop sheet or rug to avoid scratching.

•

In the event of missing or damaged parts, contact our customer support team via your Amazon account.

Summary of content (6 pages)

PAGE 1
0' (3.0m) OFFSET LED PATIO UMBRELLA PLEASE READ CAREFULLY AND RETAIN FOR FUTURE REFERENCE SAFETY WARNING Offset patio umbrellas are designed to provide protection from the sun NOT the wind. • NEVER open or operate this umbrella in wind conditions greater than 5mph (8kph). • NEVER use the tilt function in any wind (even a light breeze). • NEVER use excessive force on the crank handle to open or close the umbrella.
PAGE 2
WHAT’S IN THE BOX Item Part Qty Part Description A 1 Lower Cross Base B 1 Upper Cross Base C 1 Central Spigot 4 Hex Bolt M10*20mm 4 Washer M10 F 1 Main Frame and Canopy G 1 Solar Panel 1 Wrench M10 5 Spare LED Light Covers (if required) D M10 E M10 H M10 I ASSEMBLY INSTRUCTIONS Step 1 Step 2 Place the upper cross base (B) over the lower cross base (A). Using the M10 wrench fix the central spigot to the assembled cross base with 20mm M10 hex bolts and M10 washers.
PAGE 3
Step 3 Step 4 Step 5 Step 6 Locate the plug at the top of the umbrella. Carefully insert the plug into the socket located on the underside of the solar panel. Place the assembled cross base in your preferred location then follow the 'Cross Base Installation Tips' on page 5. Place the solar panel on the top of the umbrella taking care to conceal the wires inside the gap at the top of the umbrella, then gently turn the solar panel in a clockwise direction to attach it to the umbrella.
PAGE 4
Step 4 Step 3 Turn the crank handle in a clockwise direction to open the canopy (take care not to keep winding the crank handle once the canopy is fully opened). Use the tie strings provided at the back of the canopy to secure it to the main umbrella pole. When the umbrella arm is fully extended, lock the lift clamp and slide the lock cover into place as shown.
PAGE 5
REPLACING THE BATTERIES The batteries in your LED umbrella must be replaced at least once every year (or when you feel that the light is fading more quickly). You can purchase replacement batteries at specialty retailers. You will need 3 pieces AA size 1.2v 800mAh NIMH rechargeable batteries which are the same as have been supplied from new. Failure to insert batteries in the correct polarity, as indicated in the battery compartment, may shorten the life of the batteries or cause them to leak.
PAGE 6
CUSTOMER SUPPORT Please contact us via your Amazon account before leaving any negative review or feedback on Amazon. Your complete satisfaction matters to us, so if our product hasn’t met or exceeded your expectations, or if you are having problems with assembly, missing or damaged parts, before you do anything else please email our support team directly, let us know the full details of the issue (attaching clear pictures to your email will always help us to better understand exactly what's gone wrong).