Instructions / Assembly

STEP 11

Turn dial counter-clockwise and the piezo igniter should ignite the unit flame.

Step 12

Set dial to desired flame height.

Warning: Ensure that no parts of your body, clothing, or any other combustible material are above the burner

before, during and after ignition.

Periodic Inspection of burner flames:

Upon igniting the appliance, visually verify that the burner is indeed burning as demonstrated in the image

below. The presence of flames will confirm that the burner is burning. Periodically check that the burner flame

is present during operation by visually inspecting the burner to ensure the presence of flames.

If there are no flames present, the appliance is likely not burning. If this is the case, IMMEDIATELY turn the valve

to the “off” position if it is not already and repeat the ignition procedure as outlined in Steps 7-12.

NOTE:When fire pit is on:The burner will display blue and yellow flames. These flames should not be yellow or

produce thick black smoke. This would indicate an obstruction of airflow through the burners. The flame should

be blue and straight yellow tops. If excessive yellow flames are detected, turn off the burner.

Extinguishing the appliance:

Step 1

Turn cylinder valve to the “Closed” position.

Step 2

Turn appliance valve to the “Off” position by pushing and turning knob clockwise.

Step 3

Allow unit to cool for at least five (5) minutes before relighting.

MAINTENANCE