Instructions / Assembly

NOTE TO CONSUMER:

Please retain and refer to this guide for as long as you are in possession of this appliance.

Owner’s Manual

STEP 1

Enclosed are four bags of rocks and one factory installed 10' propane-rated hose with attached regulator.

STEP 2

Remove plastic bags containing the rocks.

STEP 3

Open the bag containing the smaller rocks labeled conveniently for you “Put Me In First" and arrange in burner

area.

STEP 4

Next, open the bag of medium sized rocks, labeled conveniently for you “Put Me In Second" and place over

small rocks.

STEP 5

Finally open the bag of larger rocks, labeled conveniently for you “Put Me In Last” and arrange over top of the

medium rocks.

STEP 6

The fourth bags of rocks are included as spares and are labeled "Spare Rocks."

Note To User:

Cover must be removed when burner is in operation.

Before igniting the unit for the first time, follow steps one through 5 in the below Ignition section.

Mix a solution of liquid soap and water in a spray bottle, and apply to the gas fittings you have just connected.

If parts of the fitting begin to produce bubbles, spray liquid, or if you smell liquid propane gas, immediately

close the valve on the tank, and leave the unit for at least an hour undisturbed to allow excess gas to escape.

After an hour, disconnect the hose and take the unit to a certified propane technician for consultation.

Rocks are not to exceed a maximum weight of 5 kgs or 11 lbs.

STEP 7

Ensure that unit valve dial is in the “OFF” position by pushing and turning clockwise until the dial stops.