User's Manual

BlueTone
™
BTSHS102 User Manual
. 10
ID (or passkey). This ensures that a unique and encrypted wireless link between your Stereo Headset and handset will
be used during calls.
Detailed operation procedures are as follows:
1. Place your Stereo Headset close to your Bluetooth handset, and ensure your Stereo Headset is power off, your
handset is power on
2. Press and hold K1 for at least 6 seconds until the Blue and Red LEDs alternate continuously. You will hear 2
power up tones, 2 more power up tones to indicate that the Stereo Headset has successfully entered the paring
mode
3. Following your phone user guide to active Bluetooth device search on the phone side, on your phone screen you
will see a list of Bluetooth equipments found by the phone at the end of the searching process.
4. Select this Bluetooth Stereo Headset ”BTSHS102” from the list and initiate pairing following handset’s on-screen
prompts.
5. Continue to follow on-screen prompts to enter passkey “0000”and confirm to pair the Stereo Headset with your
handset. When Blue LED gives 3 quick blinks per 2 seconds. This indicates pairing is completed.
Note
：
1. If pairing is successful, Stereo Headset’s Red LED is off. The Blue LED gives 3 quick blinks per 2 seconds. If
paring is failed
， the Blue and Red LEDs alternate continuously (for about 2 minutes). You need to go back to
above steps 3-5 to repeat the paring process.
2. Your Stereo Headset will remain in the pairing mode for about 2 minutes. If paring cannot be finished within 2
minutes, the Stereo Headset will enter into the standby mode (without Bluetooth connection in this case and Blue
LED gives 1 blink per 3 seconds). You need to repeat the above steps 2-5 to restart the pairing process.
2.4.1.2 Erase all paired profiles
This Stereo Headset can be paired with up to 8 Bluetooth equipments. When Stereo Headset in the Paring Mode, long
press K4, it will erase all paired profiles and quit pairing mode. At this time, Blue LED gives 1 blink per 3 seconds.
2.4.1.3 Connecting/Disconnecting your Stereo Headset with Bluetooth Equipment
When working with bluetooth equipment using HFP, your Stereo Headset cannot communicate with the equipment
without bluetooth connection established in advance.
Connecting your Stereo Headset with Bluetooth Handset：
Bluetooth connection can be set up by initiating request from either the Stereo Headset or the handset, detailed
operations are as follows:
1. Initiating connection request from the Stereo Headset: Place the Stereo Headset close to the Bluetooth handset
and then short press K2.
2. Initiating connection request from the Bluetooth handset: Place the Stereo Headset close to the Bluetooth handset
and then follow the handset user guide to find the Stereo Headset and send connection request.
Disconnecting your Stereo Headset with Bluetooth Handset:
When Stereo Headset connected with bluetooth handset, you can disconnect them as follows: