User's Manual

BlueTone™ BTHF080 User Manual
3. Quick User Guide
You can follow the instructions listed in Table 1-5 below to operate your headset. (Please refer section 1.4 and 1.5
for details of key and key press duration definitions.)
Note: your handset can only talk to paired Bluetooth handsets. For handsets supporting HFP only, you also need
to establish Bluetooth connection between your headset and your phone before making and answering calls.
Table 1: Power on/off
CURRENT STATUS HEADSET INDICATOR
FUNCTION
HANDSET HEADSET
OPERATION
AUDIO TONE LED INDICATOR
Turn On
headset
Power Off Long press K1 2 sharp tones Blue LED gives 5 quick
blinks following by 1 blink
per 3 seconds, The Red LED
is off.
Turn off
headset
Standby Long press K1 Key tone then 2
low tones
Red LED gives 5 quick
blinks and then turns off.
Table 2: Pairing/Connections
CURRENT STATUS HEADSET INDICATOR
FUNCTION
HANDSET HEADSET
OPERATION
AUDIO TONE LED INDICATOR
Enter
pairing
mode
Power Off Very long press K1 Key tone then 2
sharp tones
Red and Blue LEDs flash
alternatively
Quit from
pairing
mode
Paring Mode Short press K1 Key tone Stop alternative flashing. Blue
LED starts blinking once
every 3 seconds and Red LED
is off.
Pair headset
with handset
Power on Paring mode Follows your handset
user guide to complete
pairing procedure.
Passkey is ‘0000’
Stop alternative flashing, Blue
LED either blinks 3 times
every 3 seconds (with
connection) or blinks once
every 3 seconds (no
connection). Red LED is off.
Connect
(headset
with
handset)
Standby
(disconnect
ed)
Standby
(disconnecte
d)
Short press K1 or set up
connection via
operating the handset
One sharp/low
tone for
connection
successful/fail
If successful, Blue LED blinks
3 times every 3 seconds. Red
LED is off.
Disconnect Standby
(connect)
Standby
(connect)
Refer to handset’s
manual to initiate the
connection from the
handset side.
Low tone Blue LED blinks once every 3
seconds. Red LED is off.
. 11