User's Manual
Table Of Contents
- Certification and Safety Approvals
- 1. Introduction
- 1.1 Bluetooth Technology
- 1.2 Product Features
- 1.3 Package Content
- 1.4 Overview
- 1.5 Key Press Duration Definitions
- 2. Using Your Headset
- 3. Quick User Guide
- 4. Important Messages and Frequently Asked Questions
- 5. Maintenance
BlueTone™
BTHF106 User Manual
2. Your headset will remain in the pairing mode for about 2 minutes. If paring cannot be finished within 2
minutes, the headset will enter into the standby mode (without Bluetooth connection in this case). You need to
repeat the above steps 2-5 to restart the pairing process.
2.4.2 Pairing your Headset with Other Bluetooth Equipment
In addition to Bluetooth phone, your headset can also pair with other Bluetooth equipment for realizing short
distance wireless communications. Similar pairing procedures described in the previous section 2.4.1 can be used.
You can follow the user guide of the Bluetooth equipment to complete paring operations on the equipment side.
This headset can paired with up to 8 Bluetooth equipments (including mobile handsets). The corresponding 8 sets
of pairing information are recorded in a table maintained by the headset. Each paired equipment can wireless
communicated with the headset after setting up a Bluetooth connection. Please check section 2.4.4 on procedures to
set up a Bluetooth connection.
2.4.3 Quit paring with Bluetooth Equipment
When headset in the paring mode, short press K1, it will quit from paring mode. At this time, Blue LED starts
blinking once every 3 seconds.
2.4.4 Connecting/Disconnecting your Headset with Bluetooth Equipment
When the headset communicates with a Bluetooth equipment with Handsfree Profile, the Bluetooth connection
between two equipments shall be established in advance. If two Bluetooth equipments have been paired recently,
you can simply reconnect them.
Connecting your Headset with Bluetooth Handset：
Bluetooth connection can be set up by initiating request from the handset, detailed operations are as follows:
Place the headset close to the Bluetooth handset and then follow the handset user guide to find the headset and send
connection request. If successful, Blue LED blinks 3 times every 3 seconds.
Disconnecting your Headset with Bluetooth Handset:
When headset connected with Bluetooth handset, you can disconnect them as follows:
1. The Bluetooth connection could be unexpectedly dropped due to too far (>10m) distance or bad radio
environment.
2. Refer to handset’s manual to initiate the connection from the handset side.
After disconnecting, Blue LED blinks once every 3 seconds, Red LED is off.
2.5 Call Functions
2.5.1 Call
Before dialing, both your headset and handset must be power on. And you also need to ensure your headset and
handset has been linked with Bluetooth connection.
Answer Call: Short press K1.
Reject Call: Long press K1.
You also can long or short press K2 and long or short press K3 to reject call.
. 9