User's Manual
Table Of Contents
- Certification and Safety Approvals
- 1. Introduction
- 1.1 Bluetooth Technology
- 1.2 Product Features
- 1.3 Package Content
- 1.4 Overview
- 1.5 Key Press Duration Definitions
- 2. Using Your Headset
- 3. Quick User Guide
- 4. Important Messages and Frequently Asked Questions
- 5. Maintenance
BlueTone™
BTHF106 User Manual
b）back
Figure 3：How to Use Ear Hook
Note: To get the best performance, you need to wear your headset and Bluetooth phone on the same side of your
body and ensure there are no obstructions (including parts of your body) between them.
2.3 Turn On/Off Headset
Turn on the Headset: Long press K1, you will hear 2 high tones, and Blue LED gives 5 quick blinks following by
1 blink per 3 seconds. Red LED is off. This indicates the headset is power on.
Turn off the Headset: Long press K1, you will hear 2 low tones, and Red LED gives 5 quick blinks and then turns
off. This indicates the headset is power off.
2.4 Pairing/Connecting your Headset with Bluetooth Equipment
2.4.1 Pairing your Headset with Bluetooth Handset
Before making and answering calls, you must pair your headset and phone. Paring sets up a unique relationship
between your headset and your handset. The handset will memorize the headset’s unique ID (or passkey). This
ensures that a unique and encrypted wireless link between your headset and handset will be used during calls.
Detailed operation procedures are as follows:
1. Place your headset close to your Bluetooth handset, ensure your headset is power off and your handset is power
on
2. Press and hold K1 for at least 6 seconds until the Blue and Red LEDs flash alternatively. You will hear
2 high
tone follows by 1 high tone to indicate that the headset has successfully entered the paring mode
3. Following your phone user guide to active Bluetooth device search on the phone side, on your phone screen
you will see a list of Bluetooth equipments found by the phone at the end of the searching process.
4. Select this Bluetooth headset “BTHS106” from the list and initiate pairing following handset’s on-screen
prompts.
5. Continue to follow on-screen prompts to enter passkey “0000” and confirm to pair the headset with your
handset. Your headset ID is now stored in the handset’s memory. When Blue LED either blinks 3 times every 3
seconds (with connection) or blinks once every 3 seconds (no connection), it indicates pairing is completed.
Note
：
1. If pairing is successful, headset’s Red LED is off. The Blue LED gives 3 quick blinks per 2 seconds. If paring is
failed
，
the Blue and Red LEDs alternate continuously (for about 2 minutes). You need to go back to above
steps 3-5 to repeat the paring process.
. 8