User's Manual

BlueTone™ BTHF106 User Manual
3. Quick User Guide
You can follow the instructions listed in Table 1-6 below to operate your headset. (Please refer section 1.4 and 1.5
for details of key and key press duration definitions.)
Note: your handset can only talk to paired Bluetooth handsets. For handsets supporting HFP only, you also need
to establish Bluetooth connection between your headset and your phone before making and answering calls.
Table 1: Power on/off
CURRENT STATUS HEADSET INDICATOR
FUNCTION
HANDSET HEADSET
OPERATION
AUDIO TONE LED INDICATOR
Turn On Power Off Long press K1 2 high tones Blue LED gives 5
quick blinks
following by 1
blink per 3 seconds.
Red LED is off.
Turn Off Standby Long press K1 2 low tones Red LED gives 5
quick blinks and
then turns off.
Table 2: Pairing/Connections
CURRENT STATUS HEADSET INDICATOR
FUNCTION
HANDSET HEADSET
OPERATION
AUDIO TONE LED INDICATOR
Enter
pairing
mode
Power off Very long press K1 2 high tone follows
by 1 high tone
Red and Blue LEDs
flash alternatively.
Quit from
pairing
mode
Paring Mode Short press K1 1 high tone Stop alternative
flashing. Blue LED
starts blinking once
every 3 seconds.
Red LED is off.
Pair headset
with handset
Power on Paring mode Follows your handset
user guide to complete
pairing procedure.
Passkey is “0000”
Stop alternative
flashing, Blue LED
either blinks 3
times every 3
seconds (with
connection) or
blinks once every 3
seconds (no
connection).
Red LED is off.
Connect
(headset
with
handset)
Standby
(disconnect-
ed)
Standby
(disconnecte-
d)
Set up connection from
the handset
If successful, Blue
LED blinks 3 times
every 3 seconds.
Red LED is off.
Disconnect Standby
(connect)
Standby
(connect)
Refer to handset’s
manual to initiate the
disconnection from the
handset side.
Blue LED blinks
once every 3
seconds.
Red LED is off.
. 11