User's Manual

BlueTone
™
BTHF260 user manual
2. Using Your Handsfree
2.1 Battery Charging and Usage
2.1.1 Battery Charging
This device contains a rechargeable Li-Polymer battery. First-time charging time is about 4 hours. Later-on
recharging time is around 2-3 hours. Detailed charging procedures as follows:
1. Connect the car charger to the cigarette lighter.
2. Plug the connector of the charger to handsfree’s charging port to start charging. In screen the icon “ ” will
blink during charging. Once the icon turns to “
”, it indicates the battery is fully charged and you should
disconnect the charger from the handsfree and the power outlet.
You can also use the removable USB charging cable for charging the Handsfree speaker from your PC.
2.1.2 Battery Information
1. Once fully charged, the battery for handsfree supports continuous talk time up to 6 hours and standby time
about 550 hours.
2. When the battery is low, the device beeps once every 20 seconds and there is “Low Power” display in the
screen, charge the battery as described above.
Note that, over-charging will reduce battery life. If a fully charged battery is left unused, it will lose power over
time. Extreme temperature (either too hot or too cold) will also affect its ability to charge, capacity, and lifetime.
2.2 Mounting the Handsfree
It is easily to use Sun-visor Clip to fix the Handsfree device on the sun-visor over driver’s seat, or insert the vent
mount clip in the vent in the car. It can be more flexible to use the Handsfree in the car or carry out to the office
and home.
There are two magnets on the backside of the device, and you can attract the Sun-visor Clip or the Vent Mount to
them. In order to fix the Handsfree device on the sun-visor better, please clip the sun-visor to the sun visor in your
vehicle first, then attract the Sun-visor Clip to the backside of the device.
Note that, the microphone of the Handsfree must aim at the sound bearing.
Sun-visor Clip
magne
t
Figure 2 Fixing the Sun-visor Clip
. 9