User's Manual

BTHF205T

Magnetic Tip

Sun-Visor Clip

Figure 3 Attach Sun-visor Clip to Magnetic Tips

With great portability and flexibility, this device can also be used outside of car

environment such as in office and/or at home.

2.3 Initial Setup

z Have phone ready to do Bluetooth setup. Refer to Phone User Guide if required to

locate Bluetooth Setup function on phone.

z Turn on Handsfree speaker when phone gets ready. Follow user prompt

instructions to pair to your phone.

z If you have accidentally cancelled the setup process, the main command “PAIR

MODE” (said after triggering and hearing the “Say A Command prompt) will allow

you to enter pair mode and set up your phone.

2.4 Post Setup Connection issues

z Device is programmed to automatically attempt connection to your phone

whenever it is turned on. When the connection is timed out, you will hear “no

phone found” or “your phone is connected”. If it is “no phone found”, user needs

to use VR command to try to re-connect again. If it is connected user will hear

“your phone is connected”, if it is not currently connected, user will hear

“searching….”.When the connection processing is complete, user will either hear

“your phone is connected” or “no phone found”.

z To check connection status, simply use one of the voice command trigger options

below, and then say “AM I CONNECTED?” The device should respond with

current connection status. If no connection exists the device will automatically

search for a previously paired phone and attempt connection.

z If phone fails to connect, ensure that Bluetooth is enabled on the phone and re-

attempt.