User's Manual

Flaircomm Technologies Inc. 4
Address：No 211 North Urumchi Road, Suite 616, Shanghai, PRC, 200040
Telephone：[phone] Fax：[phone]
www.flaircomm.com
.
1. Key, for operating the device
2. Charging Port or USB Port, for connecting to the travel charger or USB cable
3. Red/Blue LED, for indicating device status
4. Line-in port, for connecting to the line-in jack of the multimedia player or PC
------Getting Started-----------------------------------------------
Battery Charging and Usage
Battery Charging
Connect the travel charger to the power outlet, or plug the USB Cable in PC.
Plug the connector of the charger or USB cable to AV adapter’s charging port to start charging. Both the Red and
Blue LEDs will be on during charging. Once the Red LED turns off, the battery is fully charged and you should
disconnect the charger from the AV adapter.
Battery Information
Once fully charged, the battery supports continuous working time up to 5 hours and standby time about 480 hours.
When the battery is low, the Red LED gives 1 blink per 3 seconds. If the battery voltage is less than 3V, the AV
adapter will turn off automatically.
Turning on and off
Turning on
When the AV adapter is power off：
 Press and hold the Key for at least 3 seconds, Blue LED quickly blinks 3 times, and then the AV adapter has been
turned on:
 If there is no pairing information stored within the AV adapter, the Blue and Red LEDs will alternate
continuously. It indicates that the AV adapter has entered the pairing mode.
 If the AV adapter has been paired before, the AV adapter will try to connect with paired device, and then
Blue LED gives 3 quick blink per 5 seconds.
 Press and hold Key for at least 6 seconds, Blue LED quickly blinks 3 times, and then Blue and Red LEDs
alternate continuously. It indicates that the AV adapter has been turned on and entered the paring mode.
Turning off
Press and hold Key for at least 3 seconds, all LEDs will be off. This indicates the AV adapter is turned off.
1
2
4
3