User's Manual

Flaircomm Microelectronics Confidential
11. Cautions &Warnings
11.1 EU Regulatory Conformance
Hereby, Flaircomm Microelectronics,Inc. declares that this device is in compliance with the
essential requirements and other relevant provisions of Directive 1999/5/EC.
The product is conformity with the following standards.
SAFETY (Art. 3.1(a)):
• EN 60950-1:2006+A11:2009:+A1:2010+A12:2011+A2:2013
HEALTH (Art. 3.1(a)):
• EN 62479:2010
EMC (Art. 3.1(b)):
• EN 301 489-1 V1.9.2:2011
• EN 301 489-17 V2.2.1:2012
RADIOS (Art. 3.2)
• EN 300 328 V1.9.1:2012
Notified body involved: Telefication B.V.
CE Number: 0560
11.2 Federal Communication Commission Interference Statement
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions:
(1) This device may not cause harmful interference.
(2) This device must accept any interference received, including interference that may cause
undesired operation.
CAUTION: Changes or modifications not expressly approved by the party responsible for
compliance could void the user's authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation.
This equipment generates uses and can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful interference to radio
communications.However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or television reception, which
can be determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
 Reorient or relocate the receiving antenna.
 Increase the separation between the equipment and receiver.
 Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
 Consult the dealer or an experienced radio/TV technician for help.
RF Warning Statement
To comply with FCC RF exposure compliance requirements, the antennas used for this transmitter
must be installed to provide a separation distance of at least 20 cm from all persons and must not
be co-located or operating in conjunction with any other antenna or transmitter.
This device is intended only for OEM integrators under the following conditions: