User's Manual

Software User Manual
©FJ Dynamics Technology Co., Ltd. All rights reserved.
82
Figure 3.7.14 Settings for no angle sensor
 Calibration of Accessories
Figure 3.7.15 Settings for calibration of accessories
When auto-driving path has a offset within 3 cm after the implement
is equipped, please measure the value. If the auto-driving path tends to
the left comparing to the pre-set guidance line, please select implement
offset to the left and enter the deviation value “a”, and then click OK to
save the setting; if the auto-driving path tends to the right, select
implement offset to the right and enter the deviation value a, and click