User's Manual

Software User Manual

if you want to use this function, drive the vehicle to the field edge and click

Mark the Edge to mark the current position of the vehicle as the field

edge.

2. The system will provide an alert sound and alert message for careful

driving when the vehicle travels 30m away from the marked field edge.

3. When the system warns driver, you can click Pause to suspend the

current autosteering driving and resume the manual driving mode. Then,

the alert sound and alert message will disappear immediately.

Notes for marking the field edge:

Only one field edge is allowed in the same direction.

In addition to completing commissioning and autosteering operations,

you also can check the real-time status of the operating vehicle and

undertake other system settings on the in-vehicle control terminal.

（6）Switch guidance lines

When not in the work state, you could enter the Task to switch

guidance lines and boundaries.

（7）Continue the task

In advanced mode, you may call the same task to continue if it is not

completed, and the task data will be cumulated and shown in history data.

The previous task settings will be implemented by default this time,

otherwise you need to change it manually.

When resuming the task, history task traces of the last task will appear,

with a red dotted line guiding the vehicle to the position where the last

task ended. After clicking the Start button, the red guide line will

disappear.

The red guide line is only for instruction and you can continue to work

at any position.