User's Manual

Software User Manual
©FJ Dynamics Technology Co., Ltd. All rights reserved.
III
Contents
Chapter I About This Document ............................................................................ 1
1 Purpose ............................................................................................................... 1
Chapter II Product Overview ................................................................................... 1
1 Introduction ....................................................................................................... 1
2 Main Components of the FJDynamics AT2 Auto Steer System ....... 2
3 Hardware Interfaces of Control Terminal ................................................ 3
Chapter Ⅲ Software Operation Instructions of Control Terminal .............. 4
1 Workflow Overview ........................................................................................ 4
2 Commissioning ................................................................................................. 4
2.1 Selecting a Language ......................................................................... 4
2.2 Register/Login ....................................................................................... 5
2.3 Entering Installation Information ................................................... 6
2.4 Home Screen ......................................................................................... 8
2.4.1 Main Interface of Fast Mode ................................................ 9
2.4.2 Main Interface of Advanced Mode ................................. 10
2.5 Select Correction Source ................................................................ 12
2.6 Setting Vehicle Parameters ............................................................ 17
2.7 Calibrating Angle Sensor ............................................................... 18
2.8 Vehicle Calibration ............................................................................ 23
3 Preparatory Operations .............................................................................. 28
3.1 Preparatory Operation in Fast Mode ......................................... 28
3.1.1 Confirm the Source Connection ...................................... 28
3.1.2 Getting the Heading Angle ............................................... 30
3.1.3 Adding New Guidance Line ............................................... 30
3.1.4 Import Guidance Line .......................................................... 30
3.2 Preparatory Operation for Advanced Mode ........................... 32
3.2.1 Confirm the Source Connection ...................................... 32
3.2.2 Add and Select Fields .......................................................... 32
3.2.3 Add and Select Task ............................................................. 36
3.2.4 Add and select boundary ................................................... 37
3.2.5 Add and Select Guidance Line ......................................... 40