User's Manual

Software User Manual

14. Vehicle: Shows the movement of vehicles in real-time.

15. Start task: After clicking, if the task configuration has been

completed, it will enter the operation status; otherwise, it will enter the

task configuration interface.

2.5 Select Correction Source

You can connect to three correction sources: Mobile Base Station,

Network RTK and SBAS.

1）Mobile Base Station: You need to select and power on a radio

station, and pair with it.

2) Network RTK: You can set up an RTK connection through the

network, when a CORS base station nearby and you have a local Ntrip

account or FJ CORS account. To enable this mode, you need to connect to

the network first.

3）SBAS: In this mode, instead of using a radio station or the network,

the autosteering kit receives differential data from the SBAS system to

provide differential positioning. Note that in this mode, the positioning

precision is lower, with a straight-line operation offset of about 5cm and a

row spacing offset of about 40 cm. Select this mode with caution based on

your demand.

Step 1: Click Settings > Correction Source to open the selection

screen.