Installation Instruction
Hardware Installation Instruction for FJDynamics Autosteering Kit
© FJ Dynamics Technology Co., Ltd. All Rights Reserved
2
disconnect the power switch.
Always make inspections carefully when it is necessary to turn off the power supply.
Do not place the equipment in a humid place, and keep it away from liquids.
Keep it away from high power wireless equipment such as wireless transmitter, radar transmitter,
high frequency and current devices, microwave oven.
Prevent direct or indirect contact with high voltage power supply or mains supply for fear of fatal
hazard.
2.2Installationsiterequirements
To ensure the normal operation of the equipment, the installation site shall meet the following
requirements.
Installationrequirements
Ensure that the installation location is firm enough to support the control terminals and accessories.
Ensure that the installation location is big enough for the installation of the control terminal, and that
the control terminal is free from other obstructions and barriers.
Temperatureandhumidityrequirements
In order to ensure the normal operation and service life of the equipment, the working environment
shall be of natural temperature and humidity, and high humidity and temperature shall be avoided.
In case of direct sunlight in the summer, it is recommended to take simple shading means, but
please keep it spaced from the control terminal appropriately.
The equipment shall not be operated in the environment not up to the temperature and humidity
requirements for a long time, otherwise, it will be damaged.
If the equipment is operated in the environment with high relative humidity, insulation materials may
be degraded to cause improper insulation or even electric leakage, and sometimes, the mechanical
properties of materials may be changed and metal parts may become rusty.
If the equipment is operated in the environment with low relative humidity, the insulating strip will
shrink and the static electricity will be generated, thus damaging the circuit on the equipment.
Cleanlinessrequirements
The installation and operation environment of equipment also makes demands on the content of salt,
acid and sulfide in the air. Some harmful substances will accelerate the corrosion of metal and the
aging of certain parts. Therefore, measures shall be taken to reduce the invasion of harmful gases
(such as: sulfur dioxide, hydrogen sulfide, nitrogen dioxide, chlorine).