Installation Instruction
Hardware Installation Instruction for FJDynamics Autosteering Kit
© FJ Dynamics Technology Co., Ltd. All Rights Reserved
6
38 HexagonboltM5×16 4
39 HexagonnutM5 4
40 HexagonboltM8×50 4
41 HexagonnutM8 4
42 Springwasher8 4
43 Plainwasher8 8
44 Plainwasher16 4
45 SSealingBag 1
Forinstallationofcontrol
terminalbracket,andIMU
46 Self‐tappingscrewST4.8×25F 1
47
Crossrecessedpanheadscrew,single
collspringlockwasherandplainwasher
assembliesM6×14
4
48 Nylonstrap 20
Allstandardpartsarepacke d
together
49 Suctioncupbase 2
50 LSealingBag 1
Note: The
splined sleeve, steering motor bracket and Angle Sensor bracket are not included in
this table, they are available at the dealer’s premise, and the dealer will install according to the
model.
The items listed above are for general cases only, and may be different as the actual case is (subject to
the order contract). Please check the received product carefully against the packing list or order contract.
If you have any questions or errors, please contact the dealer.
3. Installation
Please read Chapter 2 carefully and ensure that the requirements described in Chapter 2 are met.
3.1Checkbeforeinstallation
Before installation, make a detailed plan for the installation location, power supply and wiring of the
equipment, and confirm that:
The installation location is spacious enough to meet installation and cooling requirements of the
product.
The installation site meets the temperature and humidity requirements of the equipment.