SDS
Page: 3/9
Safety Data Sheet
according to OSHA HCS (29CFR 1910.1200) and WHMIS 2015 Regu lations
Revisio n: December 20, 201 9
Trade name:
Fix-A-Flat T i re Sealant/Inflator
(Cont'd. of page 2)
50.0.4
·
Environmental prec au tions
No special measures required.
·
Methods and material for containment and cleaning up
Allow to solidify. Pick up mechanically.
Send for recovery or disposal in suitable receptacles.
·
Reference to other sections
See Section 7 for information on safe handling.
See Section 8 for information on personal protection equipment.
See Section 13 for disp osal information.
7 Handling and storage
·
Handling
·
Precaution s for safe han dling:
Keep out of reach of children.
Use only in well ventilated areas.
Handle with care.
Avoid contact with the e yes and s kin.
·
Information about protection against explosions and fires:
Danger of receptacles bursting because of high vapor pr essure if heated.
·
Conditions for safe storage, including any incompatibilities
·
Requirements to be met by storerooms and receptacles:
Observe official regulations on storing p acka gings with pressurized containers.
·
Information about storage in o ne common storage facil i ty:
Store away from foodstuffs.
·
Further information about storage conditions:
Store in a cool place. Heat will increase pressure and may lead to the container bursting.
·
Specific end use(s)
No relevant info rmation available.
8 Exposure controls/personal protection
·
Control param e ters
·
Components with limit values that require monitoring at the workplace:
56-81-5 Glycerol
PEL (USA) Long-term value: 15* 5** mg/m³
m ist; *total dust **respirable fraction
TLV (USA) TLV withdrawn-insufficient data human occup. ex p .
EL (Canada) Long-term value: 10* 3** mg/m³
*mist; **mist, respirable
EV (Canada) Long-term value: 10 mg/m³
LMPE (Mexic o) Long-term value: 10 mg/m³
9004-34-6 cellulose
PEL (USA) Long-term value: 15* 5** mg/m³
*total dust **respirable fraction
REL (USA) Long-term value: 10* 5** mg/m³
*total dust **respirable fraction
TLV (USA) Long-term value: 10 mg/m³
(Cont'd. on page 4)