CDC1 Specifications
FABBRICA ITALIANA VEICOLI ELETTRICI Contents 1、 About the User Manual .................................................................................... 3 2、 Characteristics .................................................................................................. 3 3、 Functions and Display ....................................................................................... 3 4、 Buttons ............................................................................................................
FABBRICA ITALIANA VEICOLI ELETTRICI 1、 About the User Manual Dear users, to ensure better performance of your e-bike, please read carefully through the CDC1 Specifications before using it. 2、 Characteristics CDC1 products use the LCD display, double PCB, nylon buckle, ABS material shell and dip plastic parts (Figure 1). 68mm 25.4mm Figure 1 3、 Functions and Display CDC1 is a Multifunction display with integrated throttle function. The same display can match 24V, 36V and 48V batteries.
FABBRICA ITALIANA VEICOLI ELETTRICI CDC1 functions summary (Figure 2): • • • • • • • • • Total distance indicator Riding distance indicator Current speed indicator Backlight indicator (switch backlight) PAS level selection Residual battery capacity indicator Error code definition Kilometers or miles Wheel diameter selection Full Display Figure 2 4
FABBRICA ITALIANA VEICOLI ELETTRICI 4、 Buttons CDC1 has four buttons: ON/OFF, UP, DOWN and SET. Figure 3 5、 Installation Mount the display on the handlebar and then adjust the view angle.
FABBRICA ITALIANA VEICOLI ELETTRICI Figure 5 6、 Functions a. on/off Press the UP button once to turn on the display. Press and hold the UP button for 3 seconds to turn off the display. b. Backlight Press and hold 3 seconds the “–“ button to turn on or off the backlight. c. PAS level selection With the screen on, press the “+” or “-“ buttons to increase or decrease the assistance levels from 0 (no power) to 5 (max power). While in 0 assistance level, hold the throttle to activate the walking assisted mode.
FABBRICA ITALIANA VEICOLI ELETTRICI Figure 6 e. Wheel diameter selection Press the SET button and hold for 5 seconds to open the bicycle setting interface, then press the SET button again until the wheel diameter setting interface is reached. The wheel diameter selection is shown in Figure 7: With the - and + buttons select the new correct diameter. To choose a diameter other than the real one may cause malfunctions.
FABBRICA ITALIANA VEICOLI ELETTRICI 7、 Error codes The error codes are shown at the top-right of the display. Check the following Table. In case of error, please contact the Technical Support.
