Operation Manual

D
GB
F
NLIEPGRTRRUSSPLCZARA
12. Maintenance and replacement parts
Please note
Replacepartsthataresubjecttowear,suchasthesiliconegasketandotherrubberparts,regularlyafteryouhave
cooked with it about 400 times, or after 2 years at the latest, with original Fissler replacement parts. Parts that show
visible damage (e.g. tears, discolorations or deformations) or that do not fit correctly must be replaced immediately.
Otherwise,thefunctioningandsafetyofyourpressurecookercouldbeaffected.
Information on replacing parts
Silicone gasket (Fig. A-20)
See Chapter 5.
Silicone membrane (Fig. A-22)
See Fig. V
Detach the control valve from the lid and remove the old silicone membrane. Place the new silicone membrane on
the plastic rod of the traffic light indicator and press the edge onto the metal push rod as far as the beginning of the
thread.
Molded valve seal (Fig. A-23)
See Fig. W
Detach the control valve from the lid and remove the old seal. Select Setting 2 on the control valve, because this will
make it easier to mount the seal. First place the new seal over the metal push rod, then press the other side all the
way up over the tappet. Make sure that the molded valve seal is tightly placed around the control valve.
Valve base seal (Fig. A-24)
See Fig. X
Detach the control valve from the lid and remove the old seal. Put the new seal in place and make sure that the seal
is perfectly flat on both sides of the lid.
O-ring for Euromatic (Fig. A-18)
See Fig. I
The o-ring is removed/mounted on the inside of the lid. Make sure that the ring lies totally in the groove provided
for it.
Euromatic (Fig. A-18)
Toremove/mounttheEuromatic,youmustrstremovethelidhandle.Thisisverysimple,asyouonlyhavetoloosen
thescrewontheinsideofthelid.YoucanremovetheEuromaticfromthelidassoonasyouhaveremovedthe
o-ring.Formounting,guidethenewEuromaticwithouttheo-ringthroughthelidsothatthesidewiththewhiteball
is on the inside of the lid. Then you can mount the o-ring as described above.
Maintenance and replacement parts
49
100742Fissler 02_GAL_Vitavit_edition_GB.indd 49 19.07.2010 9:36:05 Uhr