Swing Instructions

7
13
Seat Tubes
•Insert the ends of the seat tubes into the holes in the hubs.
•Push the seat tubes in until you hear a “snap” (for each).
•Push down on the seat to be sure the seat is secured in both
frame hubs.
Hubs
12
•Attach a lock nut, rounded side facing out, onto one end of a
seat back wire.
•Tighten the lock nut by using the assembly tool. Turn the tool
clockwise to tighten the lock nut.
•Repeat this procedure to attach the other lock nut to the other
end of the seat back wire.
•Please throw the assembly tool away after completing this
assembly step.
Lock Nut – 2
Rounded Side
Assembly
Assembly
Tool
14
•Insert a #6 x 3.18 cm screw into each frame hub and tighten.
•Again, push down on the seat to be sure the seat is secured to
both frame hubs.
#6 x 3.18 cm Screw – 2