oven installation_guide
C
L
Keep this document handy for easy reference.
●
This Trim Kit is designed to complement your companion product if installing into 30” (760mm) wide cabinetry.
●
For contact information or if you require service, assistance or replacement parts, see your ‘Service & warranty’ booklet.
This Trim Kit is designed to be installed ONLY with the following FISHER & PAYKEL products:
- Companion Ovens
- or in combination with OB30/OB76 Ovens
2 PARTS SUPPLIED
1 CABINETRY SPECIFICATION
3 POSITION TRIM SURROUND ON CABINETRY
US CA NZ AU
COMPANION OVENS
ACCESSORY 0”/76CM TRIM KIT
INSTALLATION GUIDE
Center line mark
Center line mark
Front edge of cavity
Front edge of cavity
Trim Surround
Trim Surround dimensions
Line up the cut “V” with your cavity center mark
IMPORTANT!
●
Ensure all packaging and protective film
is removed from the Trim Surround before
installing.
1 Mark the center of your cavity at the front.
2 Mount the Trim Surround with the small lip
resting flat on the front edge of the cabinetry
shelf.
3 Center the Trim Surround by lining up the
small cut “V” in the lip with your center mark
from Step 1.
Note: If installing above an Oven, ensure both
products are centered and aligned in the
cabinetry.
Product Support
Brackets (2)
(for supporting your
companion product)
Trim Surround (1)
Phillips
1 3/4” (45mm)
screws (4)
(to secure the
Trim Surround)
Phillips
5⁄8” (16mm)
screws (8)
(to secure
the Product
Support
Brackets)
1 5/8” (42mm)
min.
18 1/2”
(470mm)
18 7/8”
(480mm)
min. 22 1/16” (560mm)
min. 22 1/16” (560mm)
FLUSH (INSET) INSTALL
FLUSH (INSET) INSTALL
FLUSH (INSET) INSTALL INSTALLATION
WITH OB30/OB76
INSTALLATION
WITH OB30/OB76
PROUD INSTALL
PROUD INSTALL
PROUD INSTALL
min. 22 1/16” (560mm)
1 5/8” (42mm)
min. 29 15/16” (761mm)
29 13/16” (757mm)
18 13/16”
(478mm)
20 7/8” (530mm)
Cutout to allow
for Ventilation
1 15/16” (50mm)
Refer to separate
Product Install
Guide
Refer to separate
Product Install
Guide
Cutout to allow
for Ventilation
1 15/16” (50mm)
1 5/8” (42mm)
18 13/16”
(478mm)
18 7/8”
(480mm)
18 1/2”
(470mm)
Proud = 22 5/8” (575)
Flush = 24 3/16” (614)
22 1/16” (560mm)
23 5/8” (600mm)
1/2” (12mm)
Dividing
Hard wood
shelf is
required
1/2” (12mm)
dividing shelf
is required
continued >
*
**
**
**
*
Cavity side walls must be
strong and structurally
supportive
●
to secure Trim Surround
●
to secure oven to
Note: Cavity Depth is
dependant on products used.
Phillips
2” (50mm)
screws (2)
(to secure the
Oven)