Installation Guide

17
Internal box
A
Anti tip
bracket kit
Anti-tip bracket
(1)
Masonry plug
(4)
#10x40 Pan Head Philips Screw
#10x40 Pan Head Philips Screw
#10x40 cross-head screw
(4)
Tools
Cross-head screwdriver
Powered driver (optional)
Pencil
IMPORTANT!
●
The anti-tip bracket and fittings supplied must be fitted to the wall
ofthefinished enclosure to withstand 220lbs (100kg) load.
●
Ensure that anti-tip bracket is installed correctly to prevent the
appliancetipping forward when door is open.
●
Ensure the bracket is secured to structural beams or wall studs
nearesttothe center of the alcove.
WARNING!
Read the following before fastening with masonry plugs and/or screws:
●
Ensure the screws avoid electrical, gas and water conduits.
●
Ensure lightweight masonry material such as cinder block
andnewconcrete (no curing time) are not used in installation.
●
Do not use metallic materials that may corrode, stain and/or
damagetheenclosure.
CAVITY PREPARATION
Attach anti-tip bracket
1
Project horizontally from the bottom edge of the finished enclosure
towards the center of the back wall.
– For 80" (2134mm) cavity installation — measure 27/16" (62mm)
downward from the projection line (A).
– For 84" (2032mm) cavity installation — measure 67/16" (164mm)
downward from the projection line (B).
This will locate the contact surface between the bracket and appliance.
2
Mark the location for placement of the anti-tip bracket. Place the bracket
so the top edge of the contact surface aligns with the mark (C).
3
Mark the locations of the screw holes on the wall based on the most
central wall stud (D).
4
Drill screw holes to the marked locations.
5
For wooden/plaster board wall installation:
– Fix the bracket to the wall with #10x40 pan head cross-head screws,
and screw tightly (E).
6
For solid wall installation:
– Hammer masonry plugs into the wall until flush.
– Fix the bracket to the wall with #10x40 pan head cross-head screws
(4x), and screw tightly (F).
A
B
Anti-tip
bracket
E
F
C
D
If the minimum 2 3/8"
(60mm) overlap cannot
be achieved, install a
solid spacer to the wall
stud behind the bracket.
IMPORTANT!
When positioning the appliance
in the cabinetry, ensure that the
anti-tip bracket overlaps the
refrigerator by a minimum 2 3/8"
(60mm) for a secure hold.
.
60mm overlap
Anti-tip
bracket
60mm overlap
Spacer
Anti-tip
bracket