Installation Guide

ManualsBrandsFisher & Paykel ManualsFrench Door Refrigerators36 Inch Built-in French Door Refrigerator with ActiveSmart Technology, Bottle Chill, Ice Maker, 16.8 cu. ft. Capacity, Sabbath Mode and Built-In Installation

!7 ASSEMBLE DOOR PANEL SET

The assembly of Fisher & Paykel (Stainless steel) door panels and custom door panels are outlined below. To protect the finish of the Fisher & Paykel Stainless

steel door panels, leave protective film on the panels when hanging and remove film only when installation is complete.

If using custom door panels, ensure they are prepared as per ‘Custom door panel installation dimensions’ section.

Hanging bracket (B)

For Fisher & Paykel door panel sets, align the

bracket to the holes and secure with M5x14 mush

Phillips SS screws (4x).

For custom panels, secure bracket with #8 x 16

mush washer screws (4x).

French door panels

Mounting handle (A)

For Fisher & Paykel door panel sets, remove the

plastic plugs from the handle holes (4x). Align the

handle to the holes and secure with M5x25 pan

head socket screws (4x).

For custom panels, ensure the handle is secured

29/16” (65mm) from the inner edge of the panel

to the center. This will avoid interference with the

bracket installation.

Drawer door panel

Mounting handle (D)

For Fisher & Paykel door panel sets, remove

the plastic plugs from the handle holes (4x).

Align the handle to the holes and secure with

M5x25 pan head socket screws (4x).

For custom panels, ensure handle screw heads

are counter sunk into the back of the panel to

avoid interference with hanging bracket.

Hanging bracket (E)

For Fisher & Paykel door panel sets, align the

bracket to the holes and secure with M5x14

mush Phillips SS screws (6x).

For custom panels, secure the bracket with

#8x16 mush washer screws (6x).

Side brackets and straps (F)

For Fisher & Paykel door panel sets, align the

brackets and straps to the holes on the side of the

panel and secure with M5 x 14 mush Phillips SS

screws (2x).

For custom panels, secure brackets with #8x16

mush washer screws (2x).

Side brackets and straps (C)

For Fisher & Paykel door panel sets, align the

brackets and straps to the holes on the side of

the panel and secure with M5x14 mush Phillips SS

screws (2x).

For custom panels, secure the bracket with #8x16

mush washer screws (2x).