Installation

31
@5 ATTACH CABINET SIDE TRIMS – [B] FIXED SCREW METHOD
IMPORTANT!
Before installing your refrigerator, ensure the dimensions of the finished enclosure are
correct for your refrigerator following the‘Product and cavity dimensions’ sections.
1
Break off the datum lip to each side
trim bracket and discard.
Repeat for all side trim brackets.
3
Position three side trim brackets on each side (refer to (B) for bracket locations).
Open the refrigerator doors. Measure 2” (50mm) from the front of cabinet (from
behind the doors), to the front of the alcove and accurately mark a vertical line (C).
Align the bracket edge with the marked line and using #8x16 mush washer screws
(2x) to fix the bracket to the cabinetry (3x).
Repeat on the opposite side.
IMPORTANT!
Inaccurate positioning of bracket can result in inability to fit side trim or gaps
between side trim and refrigerator.
A
PlasticAluminum
For 80” (2032mm) cavity installation only
2
Measure 4” (102mm) from the top, shorter
side trim and carefully cut using a fine
tooth hacksaw to a length of 76“ (1930mm).
Referto (A) for orientation of side trim.
Note: ensure cut is straight and square
as this is an exposed surface. Also ensure
the plastic part does not bend as this can
causevisual stress marks.
Repeat this process for the remaining
sidetrim.
0
Front of
cabinet
B
~
10”
(254mm)
~
40”
(1016mm)
~
69”
(1753mm)
2” (50mm)
Discard
2” (50mm)
C
If method [A] has resulted in poor fitment of side trims due to cabinet being out of spec, use method [B].