Installation

24
!9 HANG NON-WATER DISPENSING DOOR PANELS
7
Once satisfied with the alignment, secure M8
studs with M8 washer and M8 nut (E). The top of
the stud must remain below the top face of the
door panel.
8
Secure side bracket forks by tightening side
screws(F).
Repeat this process for all door panels.
Note:

For depth adjustment loosen side screws (4x),
adjustpanels and then retighten oncesatisfied.

Further adjustment of door panels can be
achieved by removing door panels then loosening
the fixing screws for the hanging bracket and
moving the bracket sideways to suit.
6
All door panels have full axis adjustment to ensure
they are flush with adjacent walls. To adjust the
height of each panel, turn the stud clockwise to raise
or counter-clockwise to lower the door panel (D).
Place a ruler on the front of the
product to check flushness top
and bottom, left and right.
IMPORTANT!
Remove protective film from white product
doors before hanging door panels.
1
Hang all door panels onto M8 studs and
align the side bracket forks onto the
refrigerator door (A).
– Ensure the forks are positioned around
the body of the side screws (M5x10 pan
head Phillips screw).
2
Push the product until the door panels
areflush.
– Depending on your installation design
this will be flush with your adjacent
cabinetry or your framework.
3
Place a ruler on the front of the product to
check flushness top and bottom, left and
right (B).
4
Ensure the gap between the top of the door
panel and the top cabinetry is no greater
than 1/4” (7mm).
– To reduce this gap, raise the product
by turning all four adjustment nuts the
same number of turns.
IMPORTANT!
Failure to follow these steps can lead to
difficulties in door panel adjustment and
cosmetic cap fitment.
5
Lock top inner panel side screws to allow
opening the doors without affecting
adjustment. (Open the left door to lock the
right screws and vice versa (C).)
For Fisher & Paykel Stainless steel door panels only.
E
D
F
A
B
C