Installation

23
1
Remove the external display
module from inside the product.
Thread the display harness
through the door panel
cavity. Ensure the grommet
isengaged.
2
Angle top display tabs into the
door panel. Ensure the harness
is free of pinching.
3
Firmly push against bottom
display tabs and insert into the
door panel until you feel it clip
securely. Ensure the display is
flush with the door panel.
!8 HANG ICE & WATER DOOR PANEL
4
Remove water tube from holder
on the refrigerator door.
5
Hang door panel onto M8 studs.
Ensure the panel is free to pivot
for water connections (A).
6
Connect display harness onto the refrigerator
door by inserting firmly until you feel it clip
securely (B).
On the external display, enable the dispenser
lock This will help prevent any water from
dispensing during water connection.
To lock, press the button for 4 seconds.
The LED above the button will illuminate.
A
B
7
Firmly push the water tube into the spigot behind the
door panel until the marked line is not visible.
Ensure the water tube is routed away from any sharp
objects, sharp corners, and not in a location where it can
be kinked or squashed when the door panel is secured,
(as this will stop water flow).
To secure door panel, follow the instructions in the next
section: ‘Hang non-Water dispensing door panels’.
For Fisher & Paykel Stainless steel door panels only.