Framed Installation Guide

15
7 CUSTOM DOOR PANEL DIMENSIONS
The drawings below apply to non-Water dispensing models only (RS36A80J). Dimensions are shown in Imperial (inches) and apply for the preparation and installation of custom door panels.
For Dwg and Dxf files of the below panel preparation download the folder on http://thekitchentools.fisherpaykel.com
All measurements to be made
from inner bottom corner.
For the second panel mirror
and repeat dimensions using
inner bottom corner as the
reference point.
Ensure handle is mounted
2⁄” from inner edge of panel
to the center – this will avoid
interference with brackets.
1⅜
16⁄
2⁄
4⅓
6⁄
24⁄
26⁄
38⅝
40
Ø⁄ REF
12x Pilot holes recommended for bracket attachment.
(Do not penetrate front surface).
15⁄
TOP PANEL – REAR VIEW
Ø⁄ REF
10x Pilot holes recommended for
bracket attachment.
(Do not penetrate front surface).
15⁄
5⅓
1⁄3⁄
19⅜
21⅓
16⅜
All measurements to be made
from top and centerline.
BOTTOM PANEL – REAR VIEW
Ensure handle screw heads are counter sunk into back
of panel to avoid interfering with hanging bracket.