Installation Guide

24
D
E
C
IMPORTANT!
●
Failure to follow these steps can lead to difficulties in door panel adjustment and cosmetic cap fitment.
●
For water dispensing door panels: Remove the protective film from the appliance doors before hanging door panels.
Ice and Water display
(Ice and Water
modelsonly)
External display module
(1)
Connect the external display module (for Ice and Water models only)
1
Remove the external display module
taped to the front of the appliance.
2
Thread the display harness through
the door panel cavity (A).
– Ensure the grommet isengaged.
3
Turn the top display tabs at an angle
into the door panel (B).
– Ensure the harness is free
ofpinching.
4
Push firmly against the bottom
display tabsand insert into the door
panel until you feel itclipsecurely.
– Ensure the display is flush
withthe door panel.
5
Remove water tube from the
holder on the appliance door (C).
6
Hang the door panel onto
M8studs.
– Ensure the panel is free to
pivot for water connections.
7
Connect the display harness onto the
appliancedoor by inserting firmly until you
feelit clip securely (D).
– On the external display, enable the
dispenser lock to prevent any water
fromdispensing during water connection.
– To lock, press the button for
4seconds. The LED above the
buttonwillilluminate.
8
Push the water tube firmly into the spigot
behind the door panel until the marked line
is not visible (E).
– Ensure the water tube is routed away
from any sharp objects or corners, and
not in a location where it can be kinked
or squashed when the door panel is
secured, (as this will stop water flow).
B
A
DOOR PANEL INSTALLATION - STAINLESS STEEL