Installation

19
!4 CONNECT TO WATER AND ELECTRICAL SUPPLY
5
Thread the free end of the water
line hose into the hole located at
the base of the refrigerator (C), and
through the back of the refrigerator.
6
At the back of the refrigerator,
loosely coil the water line hose
(
~
2 – 3 times) and fasten the end of
the hose to the cold water supply (D).
Note: Do not over-tighten the
connection. Turn the isolating faucet
on and check that all connections
are dry and free of drips.
7
At the back of your refrigerator, connect the refrigerator to the electrical supply (115VAC, 60Hz) with the
fitted plug and lead, and turn on. Ensure the refrigerator is connected to its own isolating switch. (E)
IMPORTANT!
Ensure the hose is not run over by the refrigerator when pushing into the cabinetry to prevent
damage and possible waterleaks.
WARNING!
Failure to follow this instruction can lead to serious injury or death.
8
Pushing the refrigerator into the correct position:

Stop midway, reach through base to locate power cord. Pull power cord through the front left
side of the refrigerator (F), tucking it neatly in the left side of the base (G).

Reach through base to locate the water line hose coil. Tuck the coil neatly into the front right
side of the base (H).

Push the refrigerator until the doors are in line with the frame. Ensure the refrigerator is centered.

Ensure there is firm contact between the refrigerator and anti-tip bracket with a
23/8”min.(60mm) overlap (I ).
D
C
F
23/8” min.
(60mm)
overlap
I
Final location
of power cord,
left side of base
G
Final location
of water tube,
right side of base
H
E