Installation Guide

19
!2 LEVEL YOUR PRODUCT

It is important that all four corners of the product is supported firmly onto the floor to
eliminate any movement.

Installing the appliance on a soft, uneven, or not level floor may result in twisting of the
product and poor door sealing.

Raise the product using an ⁄” (11mm) hex socket or ⁄” (4mm) hex Allen key. One
turn of height adjusting nuts is equivalent to ⁄” (1mm) height travel.
Note: maximum travel ⁄” (20mm).
2 Raise the rear of the product until the refrigerator doors are flush with the front face
of adjacent walls. Turn clockwise to raise roller or counter-clockwise to lower roller.
Repeat on opposite side.
Gently push the front of the product to check the stability, and ensure side gaps are
even with enclosure.
1 Level the front of the product until it is flush with adjacent walls. Turn clockwise to raise
roller or counter-clockwise to lower roller.
Repeat on opposite side.
!3 ATTACH SIDE TRIMS
1 Left side trim
Ensure the shorter side trim lip is facing
the top of the product (refer to A).
Insert the trim into the gap between
the left side of the appliance and
enclosure with the lip facing out.
2 Right side trim
Ensure the shorter side trim lip is facing
the top of the product (refer to B).
Insert the trim into the gap between
the right side of the appliance and
enclosure with the lip facing out.
A
B