Installation Guide

15
9 ATTACH ANTI-TIP BRACKET
IMPORTANT!
Safety requires refrigerators be stable when doors and/or drawer, are open. An anti-tip bracket and fittings supplied must be fitted to the wall of the finished enclosure to withstand
a220.5pound (100kg) load. This will prevent the possibility of the appliance tipping forward, when doors and/or drawer, are open.
When fastening with masonry plugs and/or screws:

Ensure the screws avoid electrical, gas and water conduits.

Ensure the surface the bracket is fastened to withstand a 220.5 pound (100 kg) load.

Ensure light-weight masonry material such as cinder block and new concrete (no curing time) are not used in installation.

Do not use metallic materials that may corrode, stain and/or damage the enclosure.
If a minimum 2⅜” (60mm) overlap cannot be achieved
we recommend fastening a solid spacer (wooden beam etc)
behind the bracket.
1 Ensure the length of the spacer corresponds to the
enclosure’s width. Always secure the spacer to existing
studs on the enclosure wall (refer to C).
2 Fix bracket to the wall with screws x4 (#10 x 40 pan head
Phillips screw). Ensure screws hold tight and the bracket
overlaps the appliance when it is positioned (2⅜” min.
(60mm)) for a secure hold.
WOODEN/PLASTER BOARD
WALL INSTALLATION
SOLID WALL INSTALLATION
1 Project the end of the above finished enclosure to the
center of the back wall and subtract 1¼” (31 mm). This
will locate the contact surface between the bracket and
the appliance (refer to A).
2 Fix bracket to the spacer with screws x4 (#10 x 40 pan
head Phillips screws). Ensure screws hold tight and the
bracket overlaps the appliance when it is positioned
(2⅜” min. (60mm)) for a secure hold.
1 Project the end of the above finished enclosure to the
center of the back wall and subtract 1¼” (31 mm). This
will locate the contact surface between the bracket and
the appliance (refer to A).
Ensure a structural beam/wall stud closest to the center
of the wall enclosure is located.
SPACER INSTALLATION
2 Mark screw locations to drill Ø ¼” x 1 ⅜” (Ø6.0 mm x 35 mm)
deep holes. Hammer masonry plugs into the wall until flush
x4. Fix bracket to the wall with screws x4 (#10 x 40 pan
headPhillips screws). Ensure screws hold tight.
A
2⅜” min.
(60mm)
overlap
Bracket
PROFILE VIEW
1¼” (31mm)
C
2⅜” min.
(60mm)
overlap
Bracket
PROFILE VIEW
1¼” (31mm)
Spacer
A
2⅜” min.
(60mm)
overlap
Bracket
PROFILE VIEW
1¼” (31mm)