Installation Guide

21
!5 HANGING ICE & WATER DOOR PANEL
2 Angle top display tabs into the
door panel. Ensure the harness
is free of pinching. Firmly push
against bottom display tabs
and insert into the door panel
until you feel it clip securely.
Ensure the display is flush with
the door panel.
1 Remove the external display
module from inside the product.
Thread the display harness
through the door panel cavity.
Ensure the grommet is engaged.
3 Remove water tube from holder
onthe refrigerator door.
4 Hang door panel onto M8 studs.
Ensure the panel is free to pivot
for water connections (refer to A).
5 Connect the display
harness onto the
refrigerator door by
firmly inserting until
you feel it clip securely
(refer to B).
On the external display,
enable the dispenser lock,
this will help prevent any
water from dispensing during
water connection. To lock, press
the buttonfor 4 seconds.
The LED above the button will
illuminate.
6 Firmly push the water tube
into the spigot behind the
door panel until the marked
line is not visible. Ensure the
water tube is routed away
from any sharp objects, sharp
corners, and not in a location
where it can be kinked or
squashed when thedoor
panel is secured, (as this will
stop water flow).
To secure door panel, follow
the instructions in the next
section: ‘Hanging non-Water
dispensing door panels’.
B
A