Use and Care Guide

16
WATER FILTER
To install new filter cartridge
1
Pull freezer drawer slightly open in order to fit filter
cartridge tool. Remove the red protective cap on the
spigot head. Align the filter cartridge tool over the filter.
2
Insert the filter cartridge and tool into the bottom left of
the product, as shown on the right.
3
Firmly push the cartridge in until the filter head cannot
be pushed any further. Turn 90°clockwise to tighten as
shown on the right.
4
Remove filter cartridge tool and close freezer drawer.
Replace kickstrip grille by aligning securing hooks.
Push grille firmly onto product until it clips securely.
RS36A80J and RS36A80U models only, replace air
flow divider. Align the divider underneath the grille tabs
indicator and clip onto the vanes of the bottom grille.
5
Reset the filter change icon on the display, thiswill remind you when the filter next
requiresreplacing. Please refer to the next pagefor activation.
6
Flush the water filter of any trapped air, harmless carbon fines and to also check for
leaks. Dispense 4qt (4L) of water anddiscard.
7
A few drops of water may appear out of the dispenser over the next few days as the
remaining trapped air is cleared.
To reset the filter change icon
We recommend the water filter be used from the time of installation, and the change
filter icon be reset only when a replacement is installed. Do not reset the change filter
icon before the filter is changed or the filter monitoring will be inaccurate.

To reset, press the and buttons for 4 seconds on the internal control panel.

The filter icon on the internal control panel and/or external display will no longer
illuminate.
To disable the filter change icon
If the change filter icon is disabled you will not be reminded of when to next change your
filter cartridge. We only recommend disabling this function when no filter cartridge is fitted.

To disable, press the , and buttons for 4 seconds.

We recommend that you do not disable the filter change icon if you have a filter
cartridge fitted to the connection.
IMPORTANT!

The rate of water flow through the water dispenser can slow down as the filter
cartridge accumulates any sediment which may be present in the water supplied to
your home. This varies depending upon your local water quality, which may require
your filter cartridge to be changed more frequently.

In cases of excessively reduced filter life we recommend that you consult a local
plumber or your water supplier for advice on suitable filtration requirements for the
water supplied to your home.

Filter replacement is the consumer’s responsibility and will not be covered by the
Manufacturer’s Warranty except in the case of faulty parts or materials within the
filtercartridge.

If the water has not been dispensed for some time or water has an unpleasant taste or
odor, flush system by dispensing 4qt (4L) of water.

If unpleasant taste or odor persists, you may wish to fit a new filter cartridge.
Engaging filter cartridge