Installation Guide

3
1 SAFETY AND WARNINGS 2 BEFORE INSTALLATION
Please follow the installation steps below to ensure your appliance is installed and
operatescorrectly.
Power

To ensure that the appliance is not accidentally switched off, connect your refrigerator
toitsown isolating switch. Do not plug in any other appliance at this isolating switch.

For power requirements, please refer to the information on the serial plate. This is located
atthe front right-hand side of the drawer when open.

It is essential that the appliance is properly grounded (earthed).

Connect the appliance to the electrical supply (115VAC, 60 Hz) with the fitted plug and lead.

Follow the National Electrical Code and all local codes and ordinances when installing
thisproduct.

Warning: Ground Fault Circuit Interrupters (GFCI) may trip during normal operation of
your refrigerator and interrupt the power supply. The use of a GFCI is not recommended
withthisproduct.
Location

Your refrigerator should not be located in direct sunlight or next to any heat generating
appliance such as a cooktop, oven or dishwasher.

Your product is fitted with front and rear rollers designed for moving the product
inforwards and backwards direction.

Avoid moving the product in a sides ways direction as this may damage the rollers
orthefloor covering/surface.
Plumbing

Your product must be installed by a qualified plumber or Fisher & Paykel Authorized
ServiceAgents as incorrect plumbing can lead to water leaks.

Fisher&Paykel Appliances does not accept responsibility for damage (including water
damage) caused by faulty installation or plumbing.
Door panel set

The standard appliance does not include a door panel set.

When designing custom door panels, these are only available for non-Water dispensing models.

To complete the integrated appliance for non-Water dispensing models the customer should
supply their own custom door panel set. All the hardware required to mount the door panel
sets to the refrigerator doors is supplied.

Fisher & Paykel door panel sets are available (EZKleen stainless steel door panels, model
numbers: RD3672 and RD3672U), and can be purchased through your Fisher & Paykel
dealeror online at www.fisherpaykel.com (this service is available to selected markets only).
!
WARNING!
Electric Shock Hazard
Read and follow the safety and warnings outlined in this installation
guide before operating this appliance.
Failure to do so can result in death, electric shock, fire or injury
topersons.
!
WARNING!
Cut Hazard
Take care – panel edges are sharp. Failure to use caution could result in
injury or cuts.
!
WARNING!
This appliance is top-heavy and must be secured to prevent the
possibility of tippingforward.
To ensure that the appliance is stable under all loading conditions, the
anti-tip bracket and fittings supplied must be installed according to the
following installation instructions by a professional installer.
IMPORTANT!
SAVE THESE INSTRUCTIONS
The models shown in this installation guide may not be available in all markets and are subject to change at any time. For current details about model and specification availability in your country, please go to
our website www.fisherpaykel.com or contact your local Fisher & Paykel dealer.