Installation Guide

23
!7 TOP TRIM AND HINGE END CAPS !8 INSTALL WATER FILTER CARTRIDGE
1 Secure the top trim to the
ceiling of the enclosure
with screw x1 (#8 x 16 mush
washer screw).
Repeat this process on the
opposite side.
2 Replace the left hinge end
cap. Align hinge cap to the
product, press and firmly
slide the cap to the right
(refer to A).
Hold onto the corner of
the end cap, firmly push up
and to the left to engage
securing hook. Ensure cap
is flush with the product.
3 Replace right hinge end
cap. Align hinge cap to
product, press and firmly
slide the cap to the left
(refer to B). Ensure cap is
flush with the product.
IMPORTANT!
The water filter head must be firmly pushed into the product and secured, incorrect
installation can lead to water leaks.
1 Remove the red protective cap on the
spigot head and align the filter cartridge
tool over the filter handle.
150
C
180
L
O
P
150
C
180
L
O
P
A
B
2
Pull the freezer drawer out slightly and
insert the filter cartridge and tool into
the bottom left of the product. Firmly
push the cartridge in until the filter head
cannot be pushed any further (refer to A).
A
Filter cartridge in the locked position
3 Turn 90° clockwise to tighten. Remove filter
cartridge tool and close freezer drawer.