Installation Guide

17
!0 CONNECT TO WATER AND ELECTRICAL SUPPLY
Final water tube connection
5 Position the appliance 1.5 – 2ft. (450 – 600 mm) in front of the finished enclosure
(refer to D). This will allow access behind the appliance for water and power
connections.
At the back of the appliance, cut the water tube to a suitable length for connecting
to the water outlet. Ensure there is enough tubing to pull the appliance out for
service, if required.
6 Assemble the following water fittings onto the other end of the water tube.
7 Fasten the faucet connection to the cold water supply. Take care
not to over-tighten the faucet connection. Turn isolating faucet
on and check that all connections are dry and free of drips.
8 Connecting power
At the back of your appliance adhere the power cord clip.
Connect the appliance to the electrical supply (115 VAC, 60 Hz
with thefitted plug and lead, and turn on. Ensure the appliance
isconnected to its own isolating switch.
Ensure excess power cord length is secured onto the clip (refer to E).
When pushing the appliance into position, take care not to roll over
ordamage the power cord and/or water tubing.
IMPORTANT!

Ensure water tubing is routed away from any sharp objects, sharp corners (beware of kinking the tube as this will stop water flow), and not in a location where it can be kinked or squashed.

Ensure a firm contact is observed as the appliance engages the anti-tip bracket, 2 ⅜” min. (60 mm) overlap.
1.5 – 2 ft.
(450 – 600 mm)
E
D
Insert tube Compression
sleeve
Compression
nut
Water tube