Installation Guide

21
!6 HANG ICE & WATER DOOR PANEL
2
Angle top display tabs into the door panel.
Ensure the harness is free of pinching.
Firmly push against bottom display tabs
and insert into the door panel until you
feel it clip securely. Ensure the display is
flush with the door panel.
3
Remove water tube from holder
on the refrigerator door.
4
Hang door panel onto M8 studs.
Ensure the panel is free to pivot
for water connections (A).
5
Connect display harness onto the refrigerator door
by inserting firmly until you feel it clip securely (B).
On the external display, enable the dispenser lock,
this will help prevent any water from dispensing
during water connection. To lock, press the
button for 4 seconds. The LED above the button
will illuminate.
A
B
6
Push the water tube firmly into the spigot behind the
door panel until the marked line is not visible.
Ensure the water tube is routed away from any sharp
objects, sharp corners, and not in a location where it can
be kinked or squashed when the door panel is secured,
(as this will stop water flow).
To secure door panel, refer to ‘Hang non-Water
dispensing door panels’.
For Fisher & Paykel Stainless steel door panels only.
1
Remove the external display module
from inside the product.
Thread the display harness through the
door panel cavity. Ensure the grommet
is engaged.