Installation Guide

27
IMPORTANT!
●
Failure to follow these steps can lead to difficulties in door panel adjustment and cosmetic cap fitment.
●
For water dispensing door panels: Remove the protective film from the appliance doors before hanging door panels.
Connect the external display module
(for Water dispensing model only)
1
Locate the external display
module from inside the appliance.
2
Thread the display harness
through the door panel cavity (A).
– Ensure the grommet
isengaged.
3
Turn the top display tabs at an
angle into the door panel (B).
– Ensure the harness is free
ofpinching.
4
Push firmly against the bottom
display tabs and insert into
the door panel until you feel
itclipsecurely.
– Ensure the display is flush
with the door panel.
7
Connect the display harness onto the
appliance door by inserting firmly until you feel
it clip securely (D).
– On the external display, enable the
dispenser lock to
prevent any water
from dispensing
during water
connection.
– To lock, press the
button for 4 seconds.
The LED above the
button will illuminate.
D
B
A
5
Remove water tube
from the holder on
the appliance door
(C).
6
Hang the door panel
onto M8 studs.
– Ensure the
panel is free to
pivot for water
connections.
C
9
Push the water tube firmly
into the spigot behind
the door panel until
the marked line is not
visible(E).
– Ensure the water
tube is routed away
from any sharp
objects or corners,
and not in a location
where it can be
kinked or squashed
when the door panel
is secured, (as this
will stop water flow).
E
Ice and Water display
(Ice and Water models
only)
External display module
(1)
!9 DOOR PANEL INSTALLATION — STAINLESS STEEL
8
Enable the dispenser lock to prevent any water
from dispensing during water connection. To lock,
press the button for 4seconds. The LED above
the button will illuminate.